Larco Labor Saver Mat System Bedienungsanleitung PDF herunterladen

www.larco.com

Labor Saver Self-Adhesive Mat

System Installation Instructions

The Larco Labor-Saver Self-Adhesive Mat System oﬀers an alternative

mounting method in applications where traditional trim and extrusions may

not be acceptable. It can also reduce labor costs associated with drilling holes

and fastening trim. Two or more people are required for proper installation.

Once the backing of the self-adhesive tape has been removed, extreme care

should be used in placement of the safety mat.

Spray or wipe the surface where the mat is to be mounted with a cleaning solution that contains 50:50 mixture of isopropyl

alcohol (IPA) and water.

Wipe the surface with a clean, dry cloth or paper towel until the surface is dry.

It works best to use one cloth for cleaning and another cloth for drying. Cotton rags and heavy paper towels work most

eﬃciently. Change rags or towels oen to avoid smearing or contaminating already clean surfaces.

Where heavy oils or greases are present, there may be a need to ﬁrst cut the oil with a “degreasing” solvent. Always follow

this by cleaning with an IPA/water mixture to help ensure removal of any residue or ﬁlm. Some plastics and paints may also

have additives that are low surface energy materials that can impede adhesion. These may require removal by abrading or

priming.

One way to assess cleanliness is that a surface prepared for Labor Saver Mat installation should be as clean as one being

prepared for painting.

D         

• Always clean any surface with a 50:50 IPA/water solution prior to

bonding with Larco Labor Saver Mats

• Clean heavily-oiled or greasy surfaces with degreasing solvent prior to

cleaning with IPA/water solution

• Make sure surface is dry before applying tape

• Change the cloth or towels frequently

• Abrade to remove heavy layers of dirt or oxidation

• Abrade to promote a faster bond or higher ultimate strength, if necessary

• Clean the surface with 50:50 IPA/water solution aer abrading to remove

dirt, contaminants and abrasive particles

DO NOT

• Substitute other cleaners

for IPA/water solution without a

thorough evaluation

• Clean with denatured alcohol,

mineral spirits, naphtha or

other solvent products

• Use dirty rags for cleaning

• Abrade so plastics, such

as polyeﬁns

Surface Preparation

Mounting Surface Tips

1 2

Inhaltsverzeichnis

Seite 1 - Mounting Surface Tips

www.larco.comLabor Saver Self-Adhesive Mat System Installation Instructions21The Larco Labor-Saver Self-Adhesive Mat System oﬀers an alternative mount

Seite 2 - Installation

ATEK Access Technologies10025 Valley View Road, Ste. 190 Eden Prairie, MN 55344 U.S.A. PH: 1.800.523.6996 FAX: 1.800.589.3705 +1.218.829.9797www.a

Kommentare zu diesen Handbüchern

Keine Kommentare

Larco Labor Saver Mat System Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Relais Larco Labor Saver Mat System herunter. Larco Labor Saver Mat System User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Relais Larco Labor Saver Mat System